Time, Sync & References
This section provides Practical and Technology advice for field testing of physical clock synchronization: References, Wander, 1PPS Phase, Time Error.
Cables & References
- Cable Delay Compensation & Time Error Measurement Accuracy
- What Cable Delay Compensation Value Should be Used for VeEX's Multi-band (Quad Constellation) GNSS/GPS Antenna?
- Measuring Actual Coax Cable Delay Using Relative Phase Measurements
- Measuring Accurate Coaxial Cable Delay, Using Direct Time-of-Flight with CX41 TDR | Quick Reference Guide
- What is the Application for the TX300s' RJ11 RS232 Serial Port?
Reference Clocks, GNSS/GPS, Atomic
- Using a Test Set as a Clock Signal Generator
- The Use of Atomic Clock's GNSS/GPS Disciplining & Holdover for Synchronization and Time Error Testing in the Field?
- Why is the Number of Satellites in the GNSS (GPS) 'Satellite View' Smaller than the ones in the 'Signal C/No' Table?
- What could cause the GNSS (GPS) antenna status indicator to show "Open" intermittently?
- How to Generate 1PPS and 10MHz Synchronous Clock Signals with VeEX Test Sets?
- How to Configure the Built-In Atomic Clock for Precision Timing (TE) & Frequency (Sync) Applications?
- How to Update or Upgrade the Chip Scale Atomic Clock Firmware in TX300s and RXT-1200?
- How to Configure the Precision Timing GNSS (GPS) Receiver?
- Can the GNSS (GPS) Antenna be Placed On (or Next to) a Window?
- The Use of Atomic Clock Holdover for Precision Time Applications in the Field - Quick Guide
- Can the Atomic Clock Maintain Time Sync (from GNSS/GPS) in Holdover Mode, While the Test Set is Off?
- What is the Maximum Coaxial Cable Length Allowed for GNSS/GPS Antenna Feed?
- What Type of Information is Displayed in the Atomic Clock Telemetry Log?
- What are the CLK (A) and CLK (B) SMA Clock Ports Used For?
- What Does the Sync 1PPS Button Do?
- What Does the GPS/GNSS Sync ToD Button Do?